Follow our instructions below to make your own stylish double wrap bracelet, featuring Preciosa Glass Pearls and our stylish bracelet extender. Or mix it up, and use beads of your choice!

Materials Needed: size 10 beading needle cutters, chain nosed pliers, Fireline, 2 x crimps ,  2 x calottes, 40 x 3mm Metal Beads, 20 x 4mm Glass Pearls

A= 3mm metal bead B= 4mm glass pearl C= 6mm glass pearl

1. Using a pair of cutters, cut a 40cm length of Fireline, thread your needle, thread a crimp, leaving a 10cm tail, tie two over hands knots around the crimp
   
2. Thread 1 calotte, thread the tail back through the calotte
   
3. Thread 1A,1B, 1A, 1C. Repeat this sequence until the double wrap bracelet is your desired length. (We repeated this 18 times)
   
4. Thread 1A, 1B, 1A
   
5. Thread 1 calotte, then 1 crimp
   
6. Tie two overhand knots around the crimp, use a needle to guide the knot into place so it's snug against the calotte
   
7. Thread back through the calotte and continue along the thread path, then trim using your cutters. Repeat for the tail at the other end of your bracelet
   
8. Using flat nosed pliers, close both calottes. Open one of the end loops of the bracelet extender, add to the loop of one of your calottes, and close the loop. Repeat for the other end of your bracelet.
   

See Below For Related Products